AerMet® 100 is an ultra-high strength martensitic alloy steel. Cobalt and nickel are the main alloying elements with chromium, molybdenum and carbon also added. Its exceptional properties are hardness, tensile strength, fracture toughness and ductility. AerMet® 100 is not corrosion resistant, so it must be sealed if used in moist environments.
AerMet® is a registered trademark of CRS Holdings, Inc., a subsidiary of Carpenter Technology Corporation.
Stainless Steel product forms offered at all Titanium Industries’ locations:
AerMet® 100 Applications:
- Armor
- Fasteners
- Landing Gear
- Actuators
- Ordnance
- Ballistic applications
- Jet Engine Shafts
- Drive Shafts
DISCLAIMER: Alloy data sheets are for reference only, not for design purposes.
| Chemical Composition | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| C 0.21 – 0.25% | Ni 11.0 – 12.0% | Co 13.0 – 14.0% | Cr 2.90 – 3.30% | Mo 1.1 – 1.3% | |||||
| Fe Balance | |||||||||
| PHYSICAL PROPERTIES | ||||||
|---|---|---|---|---|---|---|
| Density (lb/ft3) | Electrical conductivity (% IACS) | Thermal conductivity (BTU/h-ft-°F) | Specific heat capacity (BTU/lb-°F) | Thermal expansion (µm/m°C) | ||
| 0.285 | – | – | – | – | ||
| Mechanical Properties | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| Property | Minimum | Maximum | |||||||
| Yield Strength Range (MPa) | 1620 | 1724 | |||||||
| Tensile Strength Range (MPa) | 1931 | 1965 | |||||||
| Elongation (%) | 8.0% | 14.0% | |||||||
| Hardness (HRC) | – | 53 | |||||||
| Modulus of Elasticity (GPa): – | |||||||||
| Machineability General Index: – | |||||||||
All service center locations are AS9100 & ISO9001 accredited.
Birmingham, UK and Meerbusch, Germany service center locations are AS9100, AS9120 & ISO9001 accredited.
T.I. Approvals:
Plus a wide range of approvals from most leading OEM’s across Aerospace, Medical, Industrial, and Oil and Gas markets.